How To Install A Mailbox Post Without Concrete. Then you put the post into the ground, making sure to level it out. Someone’s car took out your mailbox post, it has an unsightly lean to it, or you just need to improve your curb appeal to sell that house.
Put a layer of dirt into the hole. Ensure where the water, gas, and other utility lines are before you dig the hole. Keeping the mailbox post as level as you can, begin pouring the dry concrete powder into the hole.
Table of Contents
Pour The Dry Mix Into The Tube.
Pour concrete mix in bucket until it is about half full. The sika post fix instructions say the hole must be 8″ inches in diameter and 36″ inches deep for a 4 x 4 post. Put your house or apartment number on the mailbox.
Position Your Mailbox 41″ To 45″ From The Road Surface To The Bottom Of The Mailbox Or Point Of Mail Entry.
Determine where you want your post to go. This will allow the mailbox to sit flat on the 1×4. Select your location for the new post and mark it with a stick or rock.
Put A Layer Of Dirt Into The Hole.
Space it evenly around the post, so that the post remains in the center of the hole. In this video, i show you how to easily install a mailbox post and mailbox without digging and without concrete…under 20 minutes by using a no dig anchoring. Tamp the sand down too a bit, then cover lightly with sod.
Set The Post Into The Form And Temporarily Stand Straight.
I set a new post for my mailbox a couple weeks ago. There is a way to install a mailbox post without concrete…or digging. Add water as directed on bag and stir.
Diy Mailbox Post Ideas | 5.
If you do not have a raised curb, contact your local postmaster for guidance. Ensure where the water, gas, and other utility lines are before you dig the hole. Make sure that you dig at least 2 feet deep for a 7 foot tall post (use this to determine your dig height based on your post).
